IMPORTANT WARNING:
Read all instructions carefully prior to installing and using this
Ceiling Hoist. Improper installation can result in personal injury
and/or damage to property. If in doubt, have this item installed by
a professional. The manufacturers and sellers of this item cannot
accept responsibility for any injury or damage caused by
incorrect installation or improper use.
1. Never exceed maximum total load of 50lbs (23 Kgs)
2. Before use, thoroughly test the hoist fully weighted with
the item intended to be stored to ensure the unit has been
installed securely and is functioning properly
3. Do not cut the rope.
1. Determine the correct distance between the two
pulley hooks (e.g. handlebars to back of seat on bicycle).
TOOLS REQUIRED:
-Philips head screwdriver
-Tape Measure
-Stud locator for ceilings and
walls covered with drywall
IMPORTANT ASSEMBLY INSTRUCTIONS:
2. Locate the ceiling joist. Transfer the distance measurement
(Step 1) so that the pulley brackets line up the correct distance
along the joist. It is also possible to mount the pulley
bracket rst onto a board which can then be
securely mounted to joists as illustrated.
3. Securely tie a double knot in the end of the cord
and feed the cord through the square hole on the end
of the pulley unit that does not have the cord locking
mechanism. The knotted end will then be between
the ceiling and pulley bracket.
4. Using the wood screws provided, carefully mount each pulley bracket
into the ceiling joist at the correct distance so the hooks will line up
(as measured in 1). Important; ensure that at least 3 screws are securely
mounted into the joist on each pulley bracket. Pre-drilling 1/8” pilot
holes will make this job easier.
5. Thread the cord through the pulleys as shown. Be sure to carefully
thread the cord down through both parts of the locking mechanism.
6
6. Mount the rope cleat at a safe height
out of reach of small children and screw
directly into a stud using two wood
screws supplied.
Raising an item
Ensure the hooks are properly located and the cord is not twisted before pulling on the cord. The auto-locking device will hold the item suspended with each pull.
Once hoisted to the correct height, wrap the excess cord securely around the cleat. Do not cut excess cord
Lowering an item
Pull the cord toward the rear pulley while maintaining tension on the cord. This will release the auto-locking mechanism so the weight of the item will now cause
the item to lower. Keeping the tension in this direction, slowly let the cord out as the item lowers. Once low enough, remove it from the hooks and wrap the cord
back on the cleat.
For hoisting some items, like Kayaks, it may be necessary in addition to use a suitable strap system with the hooks.
USAGE INSTRUCTIONS:
EL GRECO RS2100
ASSEMBLY DIAGRAM
Copyright 2008
Delta Design Company
125 Washington St. Unit #7
Phone: 1- 800 - 474 - 6615
Foxborough, MA 02035 USA
CEILING JOIST
WALL STUD
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals